Star Wars Collectibles

Engine Light Control Board for Star Wars Revell Zvezda 1/2700 Star Destroyer

Engine Light Control Board for Star Wars Revell Zvezda 1/2700 Star Destroyer

Engine Light Control Board for Star Wars Revell Zvezda 1/2700 Star Destroyer  Engine Light Control Board for Star Wars Revell Zvezda 1/2700 Star Destroyer

THE SOURCE OF CUSTOM 3D PRINTED PARTS FOR YOUR BUILD. ENGINE LIGHT CONTROL BOARD FOR REVELL/ZVEZDA 1/2700 IMPERIAL STAR DESTROYER. This light control board will allow you to precisely set any color from the RGB spectrum and the frequency/rate of flickering individually for the main and the secondary engines of the starship as well as the amount of white (saturation). There are also two extra connectors for additional two 8mm LEDs. Their color can also be adjusted.

They can be used to light up the hull or the hangar. The controller board comes pre-assembled, ready to use.

The modifications required to the kit are very simple. You will need to open up the engines to allow clear parts and LED to go through. The back of the engine block kit part will need to be lightly sanded for better adhesion to the pads. This set includes the following parts. The assembled circuit board with attached electronic components, connectors, LEDs with holders and plastic parts.

Clear parts to transmit the light the the engines and distribute it evenly. Two additional 8mm LEDs with cables and connectors attached. The board attaches to the back of the kit part with the two plastic pads and two sided tape or glue.

It can be removed later if needed by unscrewing the screws that hold the plastic pads. Colors, frequencies and the amount of white can be adjusted by turning the trimmer potentiometers with a screwdriver. The board can be powered up from any DC power source 6-16V, ideally 6-9V DC.

It has a protection from power surge and reversed polarity. It is possible adjust the lights after the hull is closed through a small opening(s) at the bottom back part of the hull. The main part of the controller is Arduino compatible board by Adafruit. It uses an upgraded version of the bootloader which allows LEDs to start working as soon as the power is turned on. Rotate the trimmer potentiometers to set your desired settings for color, frequency and saturation.

The clear parts for the bigger engines. Youtube video (If you can't see the video, please search for'Engine Light Control Board' on Youtube). Engine Light Control Board for Revell/Zvezda 1/2700 Imperial Star Destroyer - YouTube. Video will open in a new window. Thank you for checking out my listing! Please let me know if you have any questions. The item "Engine Light Control Board for Star Wars Revell Zvezda 1/2700 Star Destroyer" is in sale since Friday, March 9, 2018.

This item is in the category "Collectibles\Science Fiction & Horror\Star Wars Collectibles\Other Star Wars Collectibles". The seller is "volteco" and is located in Etobicoke, Ontario. This item can be shipped worldwide.

  • Country/Region of Manufacture: Canada


Engine Light Control Board for Star Wars Revell Zvezda 1/2700 Star Destroyer  Engine Light Control Board for Star Wars Revell Zvezda 1/2700 Star Destroyer